Amana RS2320006 - Manual (Page 34)

Genesis Control Programming Instructions
RS2320006 Rev. 0 C
−
4
7. Oven will automatically begin to heat at selected start
time.
•
OVEN ON light will turn on when oven begins to heat.
•
To adjust cook time, press COOK/CLEAN TIME pad
twice while the remaining cook time is displayed. Cook
time can then be adjusted.
•
When cooking time has elapsed an end of cycle signal
sounds and END will be displayed. Oven signal sounds
4 times, then once every 10 seconds until oven control
knob is turned to OFF. Knob must be turned to OFF
for oven to stop shut off.
8. Turn knob to OFF to cancel baking.
Self-Cleaning
Self-clean feature uses high oven temperature to clean oven
interior. For the oven to operate through a complete self-clean
cycle, the self-clean must be set when the oven is cool.
1. Prepare oven for self-cleaning. Oven bottom recess must
be checked for grease build up before beginning a
self-clean cycle.
2. Close door.
3. Push and turn oven temperature knob to CLEAN position.
•
The default self-clean cycle length of 3 hours will
display.
4. Set cycle length for self-clean.
•
Use slew pads to adjust time as necessary before oven
indicator light turns on.
•
Clean cycle can be set from two to four hours in five
minute increments.
•
Default setting for the cycle is three hours.
5. Self-clean begins.
•
OVEN ON indicator light will be on and will remain on
until the end of the cycle.
•
At the end of the self-clean cycle, the OVEN ON
indicator light will shut off.
•
At the end of the self-clean cycle, the oven will stop
heating, however, oven will remain hot.
•
The LOCKED indicator light will remain on until oven
reaches a cooler temperature. LOCKED light will flash
while door is unlocking, and then shut off when door
has unlocked. Oven cavity will be hot to the touch.
•
DO NOT attempt to open door prior to LOCKED
indicator light shutting off. When oven is cool, turn oven
knob to OFF.
Interrupting the self-clean cycle
To stop a self-clean cycle that has already started follow these
steps. If an interruption occurs mid cycle, the oven will remain
locked, even though the cycle has stopped, until the oven
cavity has cooled to a lower temperature.
1. Turn oven temperature knob to OFF position.
2. When oven has cooled to a lower temperature, LOCKED
light turns off. Door can be unlocked.
•
DO NOT force door. This can cause damage to the
latch.
Delayed Self-clean Cycle
Self-clean feature uses high oven temperature to clean oven
interior. Set oven to begin and end cleaning at later time.
Range control begins the self-clean at your specified start
time.
1. Prepare oven for self-cleaning. Oven bottom recess must
be checked for grease build up before beginning a
self-clean cycle.
2. Close door.
3. Press START COOK/CLEAN pad.
4. Set starting time for the cleaning cycle.
•
Default time is current time of day.
•
Start time can be set from current time to current time
plus 11 hours and 59 minutes.
5. Turn oven temperature knob to CLEAN.
•
Default self-clean cycle length of 3 hours will display.
6. Set cycle length for self-clean.
•
Use slew pads to adjust time as necessary.
•
Clean cycle can be set from two to four hours in five
minute increments.
•
Default setting for the cycle is three hours.
7. Self-clean cycle is set.
•
Oven cannot be used until completion of the self-clean
cycle.
•
Self-clean cycle will begin at selected start time.
•
To view start time, press the START COOK/CLEAN
pad.
•
OVEN ON indicator light will turn on when the self-clean
cycle begins and will remain on until the end of the
cycle.
•
To view the clean cycle time, press the COOK/CLEAN
TIME pad.
•
At the end of the self-clean cycle, OVEN ON indicator
light shuts off and the oven does not maintain the high
temperatures. Oven will still be hot, however.
•
The LOCKED indicator light will remain on until oven
reaches a cooler temperature. LOCKED light will flash
while door is unlocking, and then shut off when door
has unlocked. Oven cavity will be hot to the touch.
•
DO NOT attempt to open door prior to LOCKED
indicator light shutting off. Once oven is cool, turn oven
knob to OFF position.
Interrupting the self-clean cycle
To stop a self-clean cycle that has already started follow these
steps. If an interruption occurs mid cycle, the oven will remain
locked, even though the cycle has stopped, until the oven
cavity has cooled to a safe temperature.
1. Turn oven temperature knob to OFF position.
2. When oven has cooled to a lower temperature, LOCKED
light shuts off. Door can be unlocked.
•
DO NOT force door. This can cause damage to the
latch.