Save these instructions, Minimum clearances to combustible surfaces, Important safety information – Amana RS2320006 User Manual

Page 23: Warning

Advertising
background image

A–7

RS2320006 Rev. 0

Important Safety Information

SAVE THESE INSTRUCTIONS

WARNING

!

To avoid risk of the appliance tipping, it must be secured by a

properly installed anti-tip bracket. To make sure bracket has been

installed properly, remove the storage drawer or panel and look

under the range with a flashlight. Bracket must be engaged in the

rear corner of the range.

Ó 2001 Amana Appliances

Amana, Iowa 52204

Part No. 36-32055801-0

Printed in U.S.A. 03/01

WARNING

!

To avoid risk of burns or fire by

reaching over elements, cabinet

storage space located above

range should be avoided. If

cabinet storage is provided,

install a range hood that projects

horizontally a minimum of 5"

beyond the cabinet bottom to

reduce the risk.

WARNING

!

To avoid risk of electrical shock,

personal injury, or death, make

sure your range has been

properly grounded and always

disconnect it from main power

supply before servicing.

• ALL RANGES CAN TIP

• INJURY TO PERSONS

COULD RESULT

• INSTALL ANTI-TIP

BRACKET(S) PACKED

WITH RANGE

• SEE INSTALLATION

INSTRUCTIONS

Minimum Clearances to Combustible Surfaces

This range can be installed flush against right and left base

cabinets, and rear vertical wall. Range can also be installed

flush against left or right vertical wall extending above 36"

standard countertop height. The dimensions provided are

to be measured from the range itself, and not the

installation cutout for the range.
A—Minimum of 30" between top of cooking surface and

bottom of an unprotected wood or metal cabinet.

OR

A—Minimum of 24" between cooking surface and wood or

metal cabinet bottom protected by not less than ¼" thick

flame retardant millboard covered with not less than No. 28

MSG sheet steel, .015 inch thick stainless steel, .024 inch

thick aluminum, or .020 inch thick copper.
B—Minimum of 30" of protected cabinets above the range

(refer to letter A)
C—Minimum of 18" between top of countertop and bottom of

an unprotected wood or metal cabinet.
D—Maximum depth of 13" for overcounter cabinets.

&

%

$

'

Advertising