HP ProLiant BL465c Gen8 Server Blade - Manual (Page 14)

Operations 14
Remove the access panel
To remove the component:
1. Power down the server blade (on page 12 ).
2. Remove the server blade (on page 13 ).
3. Press the access panel release button.
4. Slide the access panel towards the rear of the server blade, and then lift to remove the panel.
Install the access panel
1. Place the access panel on top of the server blade.
2. Slide the access panel forward until it clicks into place.
Remove the DIMM baffle
1. Power down the server blade (on page 12 ).
2. Remove the server blade (on page 13 ).
3. Remove the access panel (on page 14 ).
CAUTION: Always disconnect the drive cables from the SAS controller before removing the
DIMM baffle. Failure to do so may result in damage to the SAS controller.
4. Disconnect the drive cables from the SAS controller.