HP ProLiant BL465c Gen8 Server Blade - Manual (Page 9)

Component identification 9
Item Description
1 Processor 2 DIMM slots
2 Processor 1 DIMM slots
3 Internal USB connector
4 Pass-thru board
5 TPM connector
6 Mezzanine connector 1 (Type A mezzanine only)
7 MicroSD card slot
8 Mezzanine connector 2 (Type A or type B mezzanine)
9
Enclosure connector
10 System maintenance switch
11 FlexibleLOM connectors (2)
12 Drive power cable connector
13 Processor socket 1 (populated)
14 Processor socket 2
15 System battery
16 HP c-Class Blade SUV cable connector
The symbols correspond to the symbols located on the interconnect bays. For more information, see the
HP ProLiant BL465c Gen8 Server Blade Installation Instructions on the HP website ( http://www.hp.com/support ).
System maintenance switch
Position Default Function
S1
Off Off = iLO security is enabled.
On = iLO security is disabled.
S2 Off Off = System configuration can be
changed.
On = System configuration is locked.
S3 Off Reserved
S4 Off Reserved
S5 Off Off = Power-on password is enabled.
On = Power-on password is disabled.
S6 Off Off = No function
On = ROM reads system configuration
as invalid.
S7 — Reserved
S8 — Reserved
S9 — Reserved
S10 — Reserved
S11 — Reserved
S12 — Reserved
To access redundant ROM, set S1, S5, and S6 to on.
When the system maintenance switch position 6 is set to the On position, the system is prepared to erase all
system configuration settings from both CMOS and NVRAM.