HP StorageWorks XP Remote Web Console Software - Manual (Page 149)

12. See the Preview list to check the settings that you have made.
•
To modify a setting, select and right-click the setting from the Preview list and then select
Modify. A window appears and allows you to modify the setting.
•
To cancel a setting, select and right-click the setting in the Preview list and then select
Cancel.
13. Click Apply to apply the settings that you have made.
NOTE: If an error occurs, the right-most column of the Preview list displays the error code.
To view detailed information about the error, right-click the error code and then select Error
Detail. An error message appears and gives you detailed information about the error.
If the URz pair which is being deleted exsists in the primary storage system, perform the pair
creation after the pair status changes to Simplex.
Figure 65 Add DKC Window
The Add DKC window displays the following settings:
•
S/N: allows you to enter the five-digit serial number of the remote storage system.
•
LDKC: allows you to enter the LDKC number of the remote storage system. 00 is displayed
when the remote storage system is an XP12000/XP10000 or XP24000/XP20000 Disk Array.
NOTE: The LDKC#01 cannot be used in this version.
•
Controller ID: allows you to enter the controller ID (model name that indicates the model) of
the remote storage system. The controller ID for an XP24000/XP20000 Disk Array is
5(XP24000/XP20000).
Establishing the Relationship between Primary and Secondary Storage Systems (Add DKC) 149