HP StorageWorks XP Remote Web Console Software User Manual
Page 150
•
Path Gr. ID: allows you to enter the path group ID. Path group IDs are used for identifying
groups of logical paths. One path group can contain up to eight logical paths.
Path group IDs are within the range of 1-FF (hexadecimal). If you select the Default check box,
the default path group ID will be set.
NOTE:
In the current version, you cannot enter path group IDs. Also, you cannot clear the
Default check box. The number of path group IDs per one remote storage system is always
1.
•
M-R Path: allows you to specify logical paths from initiator ports on the local storage system
to RCU target ports on the remote storage system.
•
Port: displays a list of initiator ports on the local storage system. Select an initiator port from
this drop-down list.
•
Pair-Port: displays a list of all ports on the remote storage system. Select an RCU target port
on the remote storage system from this drop-down list.
NOTE:
When specifying a port, you can use the keyboard to enter the port number. When
you enter the port number, you can abbreviate the port number to two characters. For example,
you can enter 1A instead of CL1-A. You can use uppercase and lowercase letters.
•
Option: opens the DKC Option window.
•
Cancel: cancels the settings you made on the Add DKC window and then closes the window.
Changing Options for Logical Paths and Storage Systems
The DKC Option window (see
) allows you to set the logical path options and
storage system options. These options will apply to the local storage system and the corresponding
remote storage system.
NOTE:
DKC is an acronym for disk controller, which controls an entire storage system. Universal
Replicator for Mainframe windows use the word DKC to indicate a storage system.
To change logical path options and storage system options, follow the procedure below. Not only
the primary storage system administrator but also the secondary storage system administrator can
perform this operation.
1.
Ensure that the Remote Web Console main window is in Modify mode.
For detailed information about how to do this, see the HP StorageWorks XP24000/XP20000
Remote Web Console User's Guide.
2.
Ensure that the DKC Operation window is displayed.
3.
In Display, select DKC.
4.
Select LDKC from the tree.
The list displays a list of remote storage systems.
5.
From the list, select and right-click the desired remote storage system.
6.
From the pop-up menu, select DKC Operation and Change DKC Option.
The DKC Option window appears (
).
7.
On the DKC Option window, change the options as desired. For detailed information about
the options, see the explanations below
8.
Click Set to close the DKC Option window.
150
Configuring Storage Systems and Logical Paths