Command line interface, Command line conventions, Accessing the sl-apm command line interface – HP ProLiant DL170e G6 Server User Manual
Page 27: Accessing the sl-apm through ssh, Accessing the sl-apm through telnet
Command Line Interface 27
Command Line Interface
Command line conventions
CLI input is case insensitive except when otherwise noted. The CLI uses a simple, case insensitive verb noun
"<target>" syntax.
Each command follows the conventions listed in the following table.
Symbol
Description
<lower case>
Denotes the variable within the symbols that must be substituted with a value, such as
a user name. Symbols must be removed.
UPPER CASE
Denotes input to be entered as shown.
Unless noted, symbol is not case-sensitive.
|
Used to separate input options.
{ }
Denotes a list of mandatory choices that you must make.
For example, SET GATEWAY {NONE | <ip_address>} must be in the form of either
of the following:
•
SET GATEWAY NONE
•
SET GATEWAY <ip_address>
[ ]
Denotes an optional argument or set of characters.
" "
Encloses command arguments that contain spaces.
Accessing the SL-APM command line interface
You can access the SL-APM through SSH, Telnet, or the serial port.
Accessing the SL-APM through SSH
1.
Using any SSH client application, start a SSH session to SL-APM.
2.
When prompted, enter the assigned IP address or FQDN of SL-APM.
3.
Enter Administrator.
4.
Enter a valid password. The CLI command prompt appears.
5.
Enter commands for SL-APM.
6.
To terminate the remote access SSH session, close the communication software or enter EXIT,
LOGOUT, or QUIT at the CLI command prompt.
Accessing the SL-APM through Telnet
1.
Start a Telnet session to SL-APM using any Telnet client application.