HP StorageWorks XP Remote Web Console Software - Manual (Page 136)

5. Select the Delete IP Address command.
6. A confirmation message is displayed. Click OK to request the delete IP address operation(s), or
click Cancel to cancel.
7. To apply the changes to the array, click Apply. Click OK. To cancel the changes, click Cancel.
Figure 96 Delete IP Address Pop-Up Menu
.
Adding A Community Name
To add a community name:
1. Change to Modify mode.
2.
Click Install ( ). Click the SNMP IP Security tab.
3. In the Community & Trap box, select and right-click on Community. The Add Community pop-up
menu is displayed (see
Figure 97 ).
4. Select the Add Community command. The Community panel (see Figure 98 ) is displayed.
5. In the Community text box, enter the desired community name. You can use up to 180
alphanumeric characters, except for ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %. You can also use
spaces, except at the beginning or the end of the name.
6. Click OK. The new community name is displayed in Community & Trap, but the changes are not
yet implemented in the array.
7. To add one or more IP addresses to the new community, see “ Adding Community IP
Addresses ” on page 139.
8. To apply the changes to the array, click Apply. Click OK.
Setting SNMP Agent Properties 136