Using tcp/ip over ethernet management port, Selecting a shared ethernet management port – HP ProLiant SL165z G7 Server User Manual
Page 11
Configuration 11
o
Serial Port Mode—9600 8, n, 1
o
Flow Control—None
o
Redirection after BIOS/POST—Enabled
o
Terminal Type—VT100
7.
For DL 165 G7 and SL 165 G7 servers, from the Remote Access Configuration, configure the BIOS
Serial Console as follows:
o
BIOS Serial Console Port—Enabled
o
BIOS Serial Console Port Baud Rate—[115200 8, n, 1]
o
Redirection after BIOS POST—Always
o
Terminal Type—ANSI
o
VT-UTF8 Combo Key Support—Enabled
8.
Review the serial port settings, and make sure the settings match the serial port communications
software settings used to connect to LO100.
9.
To return to the previous screen, press the Esc key, or to save the changes and exit Setup, press the
F10 key.
Using TCP/IP over Ethernet management port
You can configure LO100 LAN port access using two different Ethernet ports: the dedicated 10/100
LO100 management port or through a side-band connection using the server embedded NIC. The side-
band, shared, or UMP options utilize one server Ethernet port for both server network traffic and LO100
network traffic reducing the number of network cables that you must attach to the server.
Selecting a shared Ethernet management port
1.
Power on the server by pressing the Power On/Off button on the front panel.
2.
When POST displays the message, ROM-Based Setup, press the F10 key. If the server has an
administrator password configured, the system prompts you to enter the password. If the server does
not have a password configured, the main screen of the BIOS Setup Utility appears.
3.
Press the right arrow (→) key to navigate to the Advanced menu.
NOTE:
On the ML150 G6 system, the Virtual KVM and Virtual Media functions are not
available when used with the Shared NIC function. If you want LO100 Advanced Pack
features on the ML150 G6, use the dedicated NIC mode.
4.
Press the down arrow (↓) key to scroll to IPMI Configuration. Press the Enter key.
5.
Scroll to the LAN Configuration menu by pressing the down arrow (↓) key. Press the Enter key.
6.
Choose one of these options:
a. On ML110 G6 or DL120 G6, press the down arrow (↓) key to IPMI. Press the Enter key, and then
set BMC NIC Allocation to Shared.
b. On ML150 G6, set BMC NIC Mode to Shared.
c. On DL160 G6, DL160se G6, DL170h G6, DL180 G6, and SL160z G6, SL170z G6, or
SL2x170z G6, set BMC NIC Allocation to Enabled.
d. On DL165 G7, press the down arrow (↓) key to BMC NIC Allocation, then select
Dedicated/Shared. Press the Enter key.