HP ProLiant SL165z G7 Server User Manual
Page 24
Using LO100 24
Properties
Verbs
cd
version
exit
show
help
The first line of information returned by the show command is the current context. In the example, /.
is the current context. Following the context is a list of subtargets (Targets) and properties (Properties)
applicable to the current context. The verbs section (Verbs) shows which commands are available in
this context.
The show command can also be specified with an explicit or implicit context and a specific property.
An explicit context is /map1/firmware and is not dependent on the current context. An implicit
context assumes that the context specified is a child of the current context. If the current context is
/map1, then a show firmware command displays the /map1/firmware data. If a property is not
specified, then all properties are shown.
•
The load command moves a binary image from a URL to the map. The load command is used to take
a binary image from a specific source location (specified as a URL) and place it at the specified
target address. In a remote management processor implementation, the firmware downloads a full
image file using TFTP from the specified location and programs flash with the image.
•
In a remote management processor implementation, /map1/firmware is a valid target.
•
The load command supports usage only with the following options.
o
-source <location>—This option must be specified.
o
(h)elp—This option appears on the command line. The command ignores all options and
properties except -output (for terse or verbose output). These options are only valid for this
command when the -help option is used.
o
source <value>—This option specifies the target from which to transfer the binary image. The
value specified must be a valid URL. The format is //tftpserverip/path/filename. This option is
required in the command line when the load command is executed unless -help is used. The file
must be an uncompressed firmware image file that you create using the DOS ROMPAQ utility
found on the Lights-Out 100 Firmware Upgrade Diskette Utility available for download from the
HP websit
o
Specify one of the following:
o
"-oemhpfiletype csr" for loading firmware
o
"-oemhpfiletype key" for loading a key
o
"-oemhpfiletype cer" for loading a certificate
Example:
/./map1/firmware/-> load -s //16.110.181.187/404.bin -
oemhpfiletype csr
Firmware download is in progress.
BMC will be automatically reset once image is programmed and
validated.
Checking Image 197120
Erasing Memory 2227924
Dnlding/Prgming 4194304