HP ProLiant SL165z G7 Server User Manual
Page 51
Using LO100 51
Configuring network settings using the BIOS Setup Utility
To enable a static IP address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.
2.
Press the right arrow (→) key to navigate to the Advanced menu.
3.
Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
4.
To set your network BIOS settings, choose one of these options:
o
On ML110 G6 and DL120 G6 servers:
i.
Press the down arrow (↓) key to scroll to IPMI, and press the Enter key.
ii.
Press the down arrow (↓) key to scroll to LAN Settings, and press the Enter key.
iii.
Set IP Address Assignment to Static.
o
On ML150 G6 servers:
i.
Press the down arrow (↓) key to scroll to the end, and select BMC LAN Configuration.
ii.
On BMC LAN Configuration, select Static.
iii.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
o
On DL160 G6, DL160se G6, DL170h G6, DL180 G6, SL160z G6, SL170z G6, and SL2x170z
G6 servers, and DL165 and SL165z G7 servers:
i.
Press the down arrow (↓) key to scroll to scroll to the LAN Configuration menu. Press the Enter
key.
ii.
On DHCP IP Source, select Disabled.
iii.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab or period (.) key to move between address fields).
5.
Press the F10 key to save and exit.
To enable a DHCP assigned address:
i.
Press the F10 key during POST to enter the BIOS Setup Utility.
ii.
Press the right arrow (→) key to navigate to the Advanced menu.
iii.
Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
6.
On ML110 G6 and DL120 G6 servers, press the down arrow (↓) key to scroll down to LAN
Settings, press the Enter key, and then IP Address Assignment to DHCP.
7.
BIOS settings for DL170h G6, SL170z G6, and SL2x170z G6 servers are set by default. To set your
network BIOS settings for other G6 servers, choose one of these options:
o
On ML150 G6 servers:
i.
Press the down arrow (↓) key to scroll to the end, and select BMC LAN Configuration.
ii.
Set DHCP IP Source to Static.
o
On DL160 G6, DL160se G6, DL180 G6, and SL160z G6 servers:
i.
Scroll to the LAN Configuration menu by pressing the down arrow (↓) key. Press the Enter
key.
ii.
Set DHCP IP Source to Enabled.