Configuring network settings using the clp, Applying a license key – HP ProLiant SL165z G7 Server User Manual
Page 52
Using LO100 52
8.
To save and exit, press the F10 key, or to view the new IP Address, allow the server to reset and
reenter the BIOS Setup Utility.
Configuring network settings using the CLP
1.
Log in to LO100 CLP as described in the "Logging in to LO100 (on page
)" section.
9.
At the command prompt, enter cd map1/nic1.
10.
Configure the network settings by entering the following: set <network property>=<new
setting>
. Configurable valid network properties are:
o
networkaddress
specifies the IP address for the NIC. This setting is dynamic.
o
oemhp_nonvol_networkaddress
specifies the IP address stored in non-volatile memory.
o
oemhp_mask
specifies the subnet mask for NIC. This setting is dynamic.
o
oemhp_nonvol_mask
specifies the subnet mask stored in non-volatile memory.
o
oemhp_gateway
specifies the gateway IP address for the NIC. This setting is dynamic.
o
oemhp_nonvol_gateway
specifies the gateway IP address stored in non-volatile memory.
o
oemhp_dhcp_enable
specifies whether DHCP is enabled for the NIC. Boolean values are
accepted
o
oemhp_nonvol_dhcp_enable
specifies whether DHCP is enabled for the NIC and address
stored in non-volatile memory.
Applying a license key
1.
Log in to LO100 through a supported browser.
2.
To display the license activation screen, click Application License Key. If the Application License Key
option is not available, you must update the LO100 firmware. For more information, see "Updating
the firmware (on page
)."