HP StorageWorks 2.32 Edge Switch - Manual (Page 75)

Setting Up the Application
75 HA-Fabric Manager User Guide
Configuring the SNMP Agent
This section provides information to help you use the SNMP Agent module.
Setting Up the SNMP Agent
The simple network management protocol (SNMP) agent module instruments the
objects defined in the Fibre Channel Management (FCMGMT) Management
Information Base (MIB) Version 3.1 and a small number of objects defined in
MIB II. Through instrumentation of these MIB objects, the agent translates
information stored on the appliance into a form usable by SNMP management
stations.
You can configure network addresses and community names for up to 12 SNMP
trap recipients, which receive messages through SNMP for specific events that
occur on the appliance.
To configure the SNMP agent that runs on the appliance and implements the Fibre
Alliance MIB, perform the following:
1. Choose Monitor > SNMP Agent > Setup. The SNMP Agent Setup dialog
box displays, as shown in Figure 28 .
Figure 28: SNMP Agent Setup dialog box
2. Click the Trap Recipients tab.
3. Choose Enable Authorization Traps to enable or disable authorization traps
to be sent when unauthorized management stations try to access SNMP
information through the appliance.