27 replication manager cli tools, About the installation base path, Using the getctdelta command – HP XP P9000 Command View Advanced Edition Software User Manual

Page 445: Requirements, 445 using the getctdelta command, Using the getctdelta, Command

Advertising

27 Replication Manager CLI tools

This chapter describes the CLI functions supported by Replication Manager.

About the installation base path

If the XP P9000 Command View AE Common Component is not installed under the installation directory
of XP P9000 Command View AE suite products, you must set the

HRPM_CLI_BASE_PATH

environment

variable to the actual installation path. Typical cases where this environment variable setting is
necessary are:

•

An XP P9000 Command View AE suite product is installed in an environment where Common
Component has already been installed by another product.

•

An XP P9000 Command View AE suite product is upgraded to 7.4 or later in an environment
where the Common Component has already been installed by another XP P9000 Command View
AE suite product earlier than 7.0.

If the

HRPM_CLI_BASE_PATH

environment variable has not been set correctly, the Replication

Manager CLI will generate a KAVN00189-E error. If you see this error after executing a command,
check the value of

HRPM_CLI_BASE_PATH

Using the GetCTDelta command

In addition to the Replication Manager GUI, you can also export C/T Delta (write delay) history data
from the command line. Using the

GetCTDelta

command, you can output the histories of all (or

select) copy groups to a CSV-format file or the console. The command line is an alternative to generate
the information quickly without the overhead associated with the GUI.

GetCTDelta

output is in CSV format. Histories are output from the time of execution up until the date

specified by the command. The CLI output is the same as that exported from the GUI.

This topic contains the includes the following:

• Requirements

• Location

• Syntax

• Examples