HP LaserJet M9040M9050 Multifunction Printer series - Manual (Page 179)

Security features
This section explains important security features that are available for the MFP:
● Secure the embedded Web server
● Foreign Interface Harness (FIH)
● Secure Disk Erase
● Security Lock
● Authentication
● Lock the control-panel menus
Secure the embedded Web server
Assign a password for access to the embedded Web server so that unauthorized users cannot change
the MFP settings.
1. Open the embedded Web server. See Embedded Web server on page 152 .
2. Click the Settings tab.
3. On the left side of the window, click Security.
4. Type the password next to New Password, and type it again next to Verify Password.
5. Click Apply. Make note of the password and store it in a safe place.
Foreign Interface Harness (FIH)
The Foreign Interface Harness (FIH) provides a portal on the MFP. By using the FIH and third-party
equipment, you can track information about copies that are made on the MFP.
Requirements
● Windows 9X, Windows Me, Windows 2000, or Windows XP
● Access to third-party accounting hardware solutions, such as Equitrac or Copitrak devices
Use the FIH
To use the FIH, you must download and install the FIH software. The software is available from
www.hp.com/go/ljm9040mfp_software or www.hp.com/go/ljm9050mfp_software . The software is used
to enable or disable the FIH portal. Use the software to set and change the administrator personal
identification number (PIN).
Administrators can use the PIN option to configure the FIH to prevent any unauthorized changes.
Changes can be made only with the correct PIN authentication.
NOTE: It is important to remember the PIN that is assigned to the FIH administration software. The
PIN is required to make any changes to the FIH.
ENWW Security features 165