HP Color LaserJet CM2320 Multifunction Printer series - Manual (Page 174)

Change memory card default settings
The product comes with default settings that you can change for photo printing from the product control
panel.
NOTE: The default settings remain as selected until you change and save them again. If you want to
change the settings temporarily for a particular photo-printing job, see Print photos directly from the
memory card on page 163 .
1. Press Setup .
2. Use the arrow buttons to select Photo setup, and then press OK .
3. Use the arrow buttons to select one of the following menu items, and then press OK .
● Default image Size: The default image size for photos.
● Default lighter/darker: Change the light and dark setting for the image that you are printing.
● Default number of copies: Change the number of copies that you want to print.
● Default output color: Set whether you are printing in color or black and white.
● Restore defaults: This returns all photo settings to the factory defaults.
4. Use the arrow buttons to change the setting, and then press OK to save the change or, press X to
exit the menu without saving changes.
5. Repeat these steps for each menu item that you want to change.
162 Chapter 13 Photo ENWW