HP StorageWorks XP Remote Web Console Software - Manual (Page 172)

172 Hitachi TrueCopy z/OS for HP XP12000/XP10000 and SVS 200 storage systems
The MCU serial number field is used to display the TC390A information shown in Figure 77 .
Figure 77 Controller emulations
CQUERY for Fibre Channel interface
The path types and path status for Fibre Channel remote copy connections can be displayed by the
CQUERY command. The RCU controller ID can also be displayed.
The following example shows the output of the CQUERY command and
Table 44 on page 173 describes
the parameters used in the example for both serial and Fibre Channel interface.
NOTE: When the controller emulation type is 3990, the CQUERY command only displays the path types
and path status of the first four paths, even if more than four paths have been added.
NOTE:
•
The LIC LEVEL value in the following output is for example only, not valid number.
• The WWNN value in the following figure output will be valid if mode 484 is ON. If mode 484 is OFF,
the WWNN value is example only, not valid number.