HP Hitachi Dynamic Link Manager Software - Manual (Page 215)

3. Creating an HDLM Environment
193
error in the
-intvl
parameter, and the number of times that the error needs to occur
in the
-iemnum
parameter. When these parameters are omitted, the default values of
30 and 3 are used, respectively.
(5) Setting the Error Log Collection Level
The error log (the HDLM manager log (
dlmmgr
n
.log
(n indicates a file number from
1
to
16
))) collection level can be set.
Table 3-25: Values for the error log collection level setting lists and describes the
values for the error log collection level setting.
Table 3-25: Values for the error log collection level setting
If an error occurs, you might have to change the collection level to 1 or higher to collect
any log information.
The higher this value is set, the more information that will be output. As the amount of
log information to be output increases, it will take less time to overwrite the old error
log information with the new information.
The following is an example of setting up the error log collection level by using a
command:
# /opt/DynamicLinkManager/bin/dlnkmgr set -ellv 2
Specify the error log collection level as a number.
(6) Setting the Trace Level
You can set up the trace level for a trace file
hdlmtr
n
.log
(n indicates a file number
from 1 to 64).
Table 3-26: Values for the trace level setting lists and describes the possible values
for the trace level setting.
Value Description
0 No error logs are collected.
1 All information for errors of the "Error" level or higher is collected.
2 All information for errors of the "Warning" level or higher is collected.
3 All information for errors of the "Information" level or higher is collected.
4 All information for errors of the "Information" level or higher (including maintenance
information) is collected.