HP Hitachi Dynamic Link Manager Software - Manual (Page 220)

3. Creating an HDLM Environment
198
# /opt/DynamicLinkManager/bin/dlnkmgr set -audfac local0
3.10.3 Checking the Updated Settings
This chapter describes how to check the updated settings by using the
dlnkmgr
command's
set
operation after settings have been changed.
When you change some settings, you can display information about all of HDLM
function settings. The following shows an example of the command used to display the
settings information and its execution results:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version :
x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 2
Elog File Size(KB) : 1000
Number Of Elog Files : 5
Trace Level : 1
Trace File Size(KB) : 2000
Number Of Trace Files : 10
Path Health Checking : on(10)
Auto Failback : on(10)
Intermittent Error Monitor : on(2/20)
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time =
yyyy
/
mm
/
dd hh
:
mm
:
ss
#
After you have set up the collection of audit log data, use the following command to
make sure that the setting has been specified correctly:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log : on(6)
Audit Log Category : all
Audit Log Facility : local0
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time =
yyyy
/
mm
/
dd hh
:
mm
:
ss
#