HP Hitachi Dynamic Link Manager Software - Manual (Page 329)

4. HDLM Operation
307
7. If you do not want HDLM to manage one of the LUs newly recognized by the
node, set up the LU so that it is excluded from HDLM management.
For details, see 3.5.5 Using the HDLM Device Unconfiguration Function When
Performing a New Installation of HDLM. If you do not want to specify settings to
exclude the LUs from HDLM management, skip to step 8.
8. Execute the
dlmcfgmgr
utility shown below so that the HDLM driver recognizes
the LUs newly recognized by the node:
# /opt/DynamicLinkManager/bin/dlmcfgmgr -a
9. Make sure that the HDLM device of the LU recognized for the first time by the
HDLM driver is displayed by the
format
command.
Also check that the sd or ssd devices managed by HDLM are not displayed by the
format
command. Figure 4-4: Example of executing the format command
shows the example of executing the
format
command. The shaded portion
indicates the HDLM device of the LU recognized for the first time by the HDLM
driver.
Figure 4-4: Example of executing the format command
10. Check the status of the path accessing the LU recognized for the first time by the
HDLM driver.
The following shows an example of executing the command. The shaded portion