HP MPX200 Multifunction Router - Manual (Page 149)

Figure 130 iSCSI initiator properties: Targets tab
Windows initiators may display Reconnecting if NIC MTU changes after connection
has logged in
Solution. Log out of the sessions and log in again to re-establish the Connected state.
Communication between HP P6000 Command View and MPX200 is down
When communication between HP P6000 Command View and the MPX200 is down, use the
following options:
•
Option 1: Refresh using the iSCSI Controller button.
•
Option 2:
If the IPv4 management port IP address is set: ◦
1. Discover the controller. This option is exposed through iSCSI controller
→Set
options
→Discover controller.
2. Enter a valid IPv4 management IP address under Mgmt Port, and then click Save
changes.
◦ If only the IPv6 management port IP address is set, enter a valid IPv6 management IP
address under Mgmt Port, and then click Save changes.
NOTE: If you configure IPv6 on any MPX200 iSCSI port, you must also configure IPv6 on the HP
P6000 Command View management server.
HP P6000 Command View issues and solutions
Solution Issue
Click the Refresh button on the iSCSI Controller Properties
page. Discovered iSCSI controller was not found with selected
P6000 EVA.
Check the management port connection.
Check all FC connections.
HP P6000 Command View issues and solutions 149