Locating the mpx200 – HP MPX200 Multifunction Router User Manual
Page 38
2.
Click Set Options.
3.
Click Save Configuration.
4.
Select a configuration method, and then click Select (see
).
Figure 27 iSCSI controller configuration selection
Locating the MPX200
A flashing blue LED in the center of the blade indicates that the locating beacon is on.
NOTE:
The beacon turns off after 15 minutes.
Figure 28 Blue LED locating beacon
2. System power LED
1. Input fault LED
4. 1-GbE or 10-GbE iSCSI ports
3. Heartbeat LED
6. Maintenance button
5. 1–GbE iSCSI ports
8. UID beacon (blue LED)
7. 8–Gb/s FC ports
10. Management port 10/100/1000 Ethernet
9. RS-232 port
To enable or disable the locating beacon:
1.
Select the iSCSI controller.
2.
Click Locate.
3.
Click Locate ON or Locate OFF, and then click OK (
).
38
Managing MPX200 iSCSI using HP P6000 Command View