HP MPX200 Multifunction Router - Manual (Page 27)

Rack mounting the MPX200
NOTE: Use a crosshead screwdriver to perform the rack mount procedure.
To rack mount the MPX200:
1.
Attach the two chassis rails to the MPX200 chassis using three 10-32 x 1/4 in. screws for
each rail. Make sure that the end with the flange is facing the rear of the chassis
(
Figure 12 (page 27) ).
The MPX200 has multiple mounting holes to allow for adjustable setback. Secure the chassis
rails in the desired position if additional room is needed.
Figure 12 Chassis rails
26592b
1
2
2. Screws, flathead, 10-32 x 1/4 in. 1. Chassis rail
2. Assemble the front and rear rack rails; secure them loosely using four 6-32 x 1/4 in. screws
(
Figure 13 (page 27) ).
Figure 13 Rack rails
2. Front rack rail 1. Rear rack rail
3. Screw, flathead, 6-32 x 1/4 in.
Rack mounting the MPX200 27