Adding targets to the qlogic iscsi initiator – HP MPX200 Multifunction Router User Manual
Page 93
Advertising
Adding targets to the QLogic iSCSI initiator
To add HBA port targets:
1.
Click the green plus sign (
).
2.
Enter the first iSCSI target port IP address.
Figure 84 HBA Port Target Configuration window
3.
Repeat steps 1 and 2 for each MPX200 you want to add.
4.
Click Next.
5.
To activate the changes, enter the SMS password: config.
6.
Select the Target Settings tab. Verify that the HBA state is Ready, Link Up and that each target
entry state is Session Active (
).
Figure 85 Target Settings tab
Setting up the iSCSI initiator
93
Advertising