HP MPX200 Multifunction Router - Manual (Page 45)

Alternate procedure
Alternately, you can perform CLI based LUN presentation using the lunmask add command. See
Figure 40 (page 45) . Be sure to run this command for each 3PAR target port on each blade.
Figure 40 The lunmask add command
Setting up the iSCSI initiator
For instructions to configure the iSCSI host, see the HP 3PAR Implementation Guide that pertains
to your operating system, available at
http://h20000.www2.hp.com/bizsupport/TechSupport/
DocumentIndex.jsp?lang=en&cc=us&prodClassId=-1&contentType=SupportManual&
docIndexId=64255&prodTypeId=18964&prodSeriesId=5044394
.
NOTE: Multipath software is required when logging in to multiple connections.
For Windows-specific settings, see “Microsoft Windows iSCSI initiator rules and guidelines” (page
56) .
Setting up the iSCSI initiator 45