HP Hitachi Dynamic Link Manager Software - Manual (Page 213)

Check the underlined section.
6
.
If Red Hat Enterprise Linux, or SUSE LINUX Enterprise Server is being
used, check the SCSI device name in the /proc/swaps file.
The SCSI device name is displayed in the Filename column.
7
.
If the block device name or the udev name was specified in steps 3 and 4,
execute the following commands to check the SCSI device:
¢
For Red Hat Enterprise Linux 6
Execute the udevadm command. Specify the block device name for -n.
# udevadm info --query name -n /dev/disk/by-uuid/
55574d05-07dc-4c94-a585-5599c284d79b
sda2
The sda2 value output is the SCSI device name corresponding to
55574d05-07dc-4c94-a585-5599c284d79b.
¢
For SUSE LINUX Enterprise Server
Execute the udevinfo command. Specify the device name (udev
name) in the /dev/disk directory for -n.
# udevinfo -q name -n /dev/disk/by-id/scsi-2000c50fffecb6ae0-
part2
sda2
The sda2 value output is the SCSI device name corresponding to /
dev/disk/by-id/scsi-2000c50fffecb6ae0-part2.
8
.
Back up the /etc/fstab file.
9
.
Edit the /etc/fstab file, and delete the LABEL setting.
Comment out all lines for which LABEL is used, as checked in step 3, by
adding a hash mark (#) to the start of each of those lines, and then add a
line specifying the SCSI device as follows, given the correspondence
between LABEL and the SCSI device as checked in step 5.
:
:
#LABEL=/ / ext2 defaults
1 1
/dev/sda2 / ext2 defaults
1 1
#LABEL=/boot /boot ext2 defaults
1 2
/dev/sda1 /boot ext2 defaults
1 2
:
:
In addition, add a line specifying the SCSI device checked in step 6 as
shown above if the /etc/fstab file contains #LABEL=SWAP-sda3.
10
.
Back up the boot loader configuration file.
Creating an HDLM Environment
3-141
Hitachi Dynamic Link Manager User Guide for Linux ®