HP Hitachi Dynamic Link Manager Software User Manual
Page 215
title sd-Red Hat Enterprise Linux (2.6.18-194.el5)
¢
When LILO or ELILO is used as the boot loader:
Change the underlined text as follows:
Before:
label=linux
After:
label=linux-sd
13
.
Change the specification for root contained in the boot loader
configuration file from LABEL to the SCSI device, based on the LABEL and
SCSI device correspondence checked in step 5.
Change the specification for root contained in the configuration that you
copied in step 11.
If any options have been specified to suit the user environment, take care
not to delete those options.
¢
When GRUB is used as the boot loader:
Change the root specification on the kernel line to root=SCSI-
device.
¢
When LILO or ELILO is used as the boot loader:
Change the specification for root to root=SCSI-device. If no options
have been specified to suit the user environment, delete or comment
out the append line.
14
.
In the boot loader configuration file, edit the settings to be used during a
boot.
¢
When GRUB is the boot loader
Change the default number so that a boot can be performed using
the configuration copied in step 11.
default= 2
¢
When LILO or ELILO is used as the boot loader:
Specify label for default.
default linux-sd
15
.
If LILO is used as the boot loader, execute the /sbin/lilo command to
have the new settings take effect.
16
.
Restart the host to make sure that booting from the SCSI device is
possible.
17
.
Install HDLM.
To install HDLM, see
Performing a New Installation of HDLM on page
perform steps 2 to 12 to create an HDLM device. You will also need
to perform step 13 if you are only restarting the host. Note that the
procedure differs depending on whether the host is restarted after
installation.
18
.
Execute the HDLM-configuration definition utility (dlmcfgmgr) with the -v
parameter specified to check the correspondence between the SCSI
device and the HDLM device.
# dlmcfgmgr -v
Creating an HDLM Environment
3-143
Hitachi Dynamic Link Manager User Guide for Linux
®