Ilo reports, Deleting an ilo, Adding an ipdu – HP Smart Update Manager User Manual
Page 55: Ilo reports deleting an ilo
NOTE:
If HP SUM cannot successfully deploy all updates in a node, it does not reboot the
node. View the deployment logs to find and resolve the issue before you reboot the node.
7.
HP SUM displays a list of updates that are available. You can select or deselect updates that
you don’t want to perform.
8.
Click Analysis, and then click Deploy to begin the deployment.
NOTE:
To begin the deployment, all dependency issues must be resolved, for example,
adding a baseline, administrator credentials, and supported installed versions.
9.
Click View log for the node, in the General section of the Node screen, and then click View
log for the component you installed, to view the details of the installation.
iLO reports
1.
From the iLO screen, highlight the iLO for which you want to generate reports.
2.
Click Actions
→Reports.
3.
The iLO Reports procedure is the same as the Node Reports procedure.
To generate a report
1.
From the Nodes screen, select a report or multiple reports, and then click Actions
→Report.
2.
Select the reports you want to generate:
•
Firmware details: This displays firmware versions that are currently installed on the node.
•
Deploy preview: This displays components that HP SUM can install on the node.
•
Failed Dependency details: This displays any failed dependencies on the node.
•
Last deploy details: This displays details about what HP SUM installed on a node.
NOTE:
If you cannot select a report, HP SUM might not have enough information to generate
the report.
3.
Click the report format you want HP SUM to generate, HTML, CSV, or XML.
NOTE:
HP SUM automatically opens the report after it finishes generating the report. If you
do not have the format associated to an application, HP SUM prompts you to save the report.
4.
Click Generate.
Deleting an iLO
1.
From the iLO screen, highlight the iLO.
2.
Click Actions
→Delete.
3.
Click Yes, delete.
Using the Intelligent Power Distribution Units screen
The iPDU screen displays only iPDU nodes that you have added to HP SUM.
Adding an iPDU
1.
From the iPDU screen, click Add Node.
2.
The Add iPDU procedure is the same as the Add Node procedure.
To add a node
1.
From the Nodes screen, click Add Node.
Using the Intelligent Power Distribution Units screen
55