HP PSC 1315 All-in-One Printer - Manual (Page 14)

hp psc 1310 series
chapter 1
6
quic
k star
t
use your hp psc with a computer
If you installed the HP psc software on your computer according to the Setup
Poster, you can access all the features of the HP psc using the HP Director.
This section contains the following topics:
• open the hp director for Windows users on page 6
• open the hp director for Macintosh users on page 8
open the hp director for Windows users
1 Do one of the following to open the HP Director:
– Double-click the HP Director icon on the desktop.
– In the Windows taskbar, click Start , point to Programs or All Programs
(XP) , point to HP , then select HP Director .
2 In the Select Device box, click to see a list of installed HP devices supported
by this software.
3 Select HP PSC 1310 Series .
Note: The HP Director graphic below might appear differently on your
computer. The HP Director is customized based on the HP device that is
selected. If your device is not equipped with a particular feature (such as fax
capability), then the icon for that feature will not display in the HP Director
on your computer. Some HP devices might show additional buttons that are
not shown below.
Tip: If the HP Director on your computer does not contain any
icons, an error might have occurred during the software
installation. To correct this, use the Control Panel in Windows to
completely uninstall the HP Director software, and then reinstall the
HP Director.
Light is
blinking. Light is
blinking. Light is
blinking. An error caused the
HP psc to stop functioning.
1 Turn the HP psc off and
then on.
2 Restart your computer.
3 If the problem is not
corrected, unplug the
HP psc and plug it in
again.
If the problem persists,
contact HP.
on light
(green) check
paper
light check print
cartridge
light explanation what to do?