HP PSC 1315 All-in-One Printer User Manual
Page 21
user guide
load originals and load paper
13
load or
iginals & paper
3
Tap the stack on a flat surface to align the edges of the paper, and then
check the paper for the following:
–
Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
–
Make sure all the paper in the stack is the same size and type.
4
Insert paper into the paper tray with the print side down until it stops. To
avoid bending the paper, make sure you do not push the paper in too far,
or push too hard. If you are using letterhead, insert the top of the page first.
Do not use too much paper. Check that the stack of paper contains several
sheets but is no higher than the top of the paper-width guide.
Note:
Forcing the paper too far into the HP psc might cause multiple sheets
of paper to be fed through the print mechanism, or cause a paper jam.
5
Slide the paper-width guide in until it stops at the edge of the paper. Make
sure that the paper stack lies flat in the paper tray and fits under the tab of
the paper-width guide.