HP Photosmart C5580 All-in-One Printer - Manual (Page 143)

Solution 1: Make sure the paper is loaded correctly
Solution: Make sure that the paper is loaded correctly in the input tray.
For more information, see:
“Load paper” on page 37
Cause: The paper was not loaded correctly.
If this did not solve the issue, try the next solution.
Solution 2: Use a higher print quality setting
Solution: Check the quality setting. Use a higher quality setting to increase the
amount of ink used for printing.
NOTE: For maximum dpi resolution, go to the Advanced tab, and then select
Enabled from the Maximum dpi drop-down list.
For more information, see:
• “Change the print speed or quality” on page 54
• “Print using Maximum dpi” on page 60
• “Change copy speed or quality” on page 88
Cause: The print quality setting was set too low.
If this did not solve the issue, try the next solution.
Solution 3: If the print cartridge was dropped, wait for it to recover
Solution: Allow 30 minutes for the print cartridge to recover.
Cause: A tri-color or photo print cartridge was jarred or handled roughly during
installation.
If this did not solve the issue, try the next solution.
Solution 4: Clean the print cartridge nozzles
Solution: Check the print cartridges. If it looks as though there are fibers or dust
around the ink nozzles, clean the ink nozzle area of the print cartridge.
For more information, see:
“Clean the area around the ink nozzles” on page 111
Cause: The print cartridge nozzles needed to be cleaned.
If this did not solve the issue, try the next solution.
Solution 5: Check the print catridges
Solution: Check the estimated ink levels in the print cartridges.
Chapter 14
140 Troubleshooting
T
roub
les
hoot
ing