HP Photosmart C5580 All-in-One Printer - Manual (Page 277)

To remove the control panel faceplate
1. Press the On button to turn off the HP All-in-One.
2. Unplug the power cord, and then disconnect it from the HP All-in-One. Do not return the power
cord with the HP All-in-One.
3. Remove the control panel faceplate as follows:
a. Place your hands on each side of the control panel faceplate.
b. Place the fingertips of your left hand in the small gap under the display, and then pry the
faceplate down and to the right.
4. Retain the control panel faceplate. Do not return the control panel faceplate with the HP All-in-
One.
CAUTION: The replacement HP All-in-One might not come with a control panel faceplate.
Store your control panel faceplate in a safe place, and when the replacement HP All-in-One
arrives, reattach your control panel faceplate. You must attach your control panel faceplate
to use the control panel functions on the replacement HP All-in-One.
NOTE: See the Start Here guide that came with the HP All-in-One for instructions on how
to attach your control panel faceplate. The replacement HP All-in-One might come with
instructions for setting up your device.
Pack the HP All-in-One
Complete the following steps once you have removed the print cartridges, removed the control panel
faceplate, turned off the HP All-in-One, and unplugged it.
To pack the HP All-in-One
1. If available, pack the HP All-in-One for shipment by using the original packing materials or the
packaging materials that came with your exchange device.
Chapter 15
274 HP warranty and support
HP w
arran
ty a
nd s
uppo
rt