HP Color LaserJet 9500 Multifunction Printer series - Manual (Page 297)

ENWW Solving output-quality problems 281
1
9
Output-quality troubleshooting procedures
For all output-quality problems and defects, perform the following procedures.
• Replace any MFP supplies that have run out. When a supply is out, the REPLACE <SUPPLY> message appears on
the control panel, and the gauge shows an empty bar with a flashing outline for the supply that is out. Printing stops
and the
REPLACE <SUPPLY> message appears on the control panel until the supply is replaced. For more
information, see “Solving output-quality problems” on page 279.
Touch H ELP to see step-by-step instructions for replacing the supply. For more information about replacing supplies
see “Replacing the print cartridges” on page 193 or “Replacing the image drums” on page 197 or “Replacing the
image transfer kit” on page 203 or “Replacing the image cleaning kit” on page 214 or “Replacing the image fuser kit”
on page 220.
To order supplies, see “Ordering supplies” on page 188.
• Print 10 more pages of your print job, or of another print job. The MFP can automatically compensate for a few
output-quality problems.
If these procedures do not solve the problem, see “Solving persistent output-quality problems” on page 282.