HP Officejet Pro 8100 ePrinter - N811a N811d - Manual (Page 23)

Install the accessories
This section contains the following topics:
•
Install the automatic two-sided printing accessory (duplexer)
• Install Tray 2
• Configure trays
• Turn on accessories in the printer driver
Install the automatic two-sided printing accessory (duplexer)
You can print on both sides of a sheet of paper automatically. For information on using
the duplexer, see Print on both sides (duplexing).
To install the duplexer
▲
Slide the duplexer into the back of the printer until the unit locks into place. Do not
press the buttons on either side of the duplexer when installing the unit; use them
only for removing the unit from the printer.
Install Tray 2
NOTE: Tray 2 is available as an optional accessory.
Tray 2 can hold up to 250 sheets of plain paper. For ordering information, see HP
supplies and accessories.
To install Tray 2
1.
Unpack the tray, remove the packing tapes and materials, and move the tray to
the prepared location. The surface must be sturdy and level.
2. Turn off the printer, and disconnect the power cord.
Install the accessories 19