HP Designjet L25500 Printer series - Manual (Page 16)

Restart the printer
In some circumstances you may be advised to restart the printer. Please proceed as follows:
1. Press the Power button on the front panel to turn the printer off. Wait a few moments, and then
press the Power button again. This should restart the printer. If it does not, continue with step 2.
2. Use the Reset button on the front panel. You will need a non-conductive implement with a narrow
tip to press the Reset button. This normally has the same effect as pressing the Power button, but
may work if the Power button does not.
3. If neither steps 1 nor 2 seems to have any effect, turn off the printer by using the power switch at
the rear of the printer. Check that the residual current circuit breakers are in the up position.
4. Remove the power cords from the power sockets.
5. Wait for 10 seconds.
6. Reinsert the power cords into the power sockets and turn on the printer by using the power switch.
7. Make sure that the Power light on the front panel illuminates. If it does not, use the Power button
to turn on the printer.
Change the language of the front panel
Two methods are available to change the language that is used for the front-panel menus and
messages.
● If you can understand the current front panel language, go to the front panel and select the icon,
and then select Front panel options > Select language.
● If you cannot understand the current front panel language, start with the printer powered off. At the
front panel, press the
OK button and hold it down. While holding down the OK button, press the
Power button and hold it down. Continue to hold down both buttons until the green light on the left
side of the front panel starts flashing, and then release both buttons. You can expect a delay of
about one second. If the green light starts flashing without any delay, you may need to start again.
Whichever method you used, the language selection menu should now appear on the front panel.
Highlight your preferred language, and then press the OK button.
12 Chapter 3 Basic setup options ENWW
Basic setup options