HP Designjet L25500 Printer series - Manual (Page 29)

Unload a roll from the printer
If you used the take-up reel during printing, unload the printed roll from the take-up reel before attempting
to remove the roll from the printer. See
Unload a roll from the take-up reel on page 34 .
Check whether the other end of the roll is still attached to the input spindle, and follow the appropriate
procedure as described in the following sections.
The normal procedure (roll attached to spindle)
If the end of the roll is still attached to the spindle, use the following procedure.
1. On the printer's front panel, select the icon, and then select Substrate unload > Unload roll.
2. Press the OK button on the front panel as many times as needed to rewind the substrate.
3. Lift the spindle lock lever.
4. Remove the roll from the printer, pulling out the right end on the right side of the printer first. Do
not insert your fingers into the spindle supports during the removal process.
Exceptional procedure (roll detached from spindle)
Use the following procedure if the end of the roll is visible but no longer attached to the spindle:
1. If you have already selected Substrate unload at the front panel, press the Cancel button to cancel
that procedure.
ENWW Unload a roll from the printer 25
Hand
le the su
bstrate