HP Designjet L25500 Printer series User Manual
Page 36
17.
Assemble a loop-shaping core by matching the shape-coded and color-coded lengths of plastic
tubing. The loop-shaping core must be the same width as the substrate that you are using. Make
sure that both end caps are firmly fitted on the ends of the loop-shaping core.
NOTE:
The front-panel display shows the required length of the loop-shaping core based on the
width of the roll that you have loaded into the printer.
18.
Gently lower the loading table, to avoid wrinkles and improve winding.
19.
Carefully insert the loop-shaping core.
NOTE:
Make sure that you insert the loop-shaping core. The take-up reel will not function
correctly without it. The loop-shaping core must have end caps. Make sure that the end caps extend
over the edges of the substrate.
32
Chapter 4 Handle the substrate
ENWW
Handle the su
bstrate