HP Designjet L25500 Printer series User Manual
Page 37
20.
Use the wind-direction switch on the take-up reel motor to select the winding direction. Setting 1
winds the substrate so that the printed image faces in. Setting 2 winds the substrate so that the
printed image faces out.
The front panel shows you the correct setting based on the winding-direction decision you made
in step 7.
21.
Press the
OK
button on the front panel. The Take-up reel has been successfully installed
message appears.
22.
The following image shows how the printer looks when it is operating. As substrate is fed from the
printer, it drops down in a loop and then up into the take-up reel spindle.
NOTE:
While the take-up reel is operating, make sure that the take-up reel sensors are not blocked.
NOTE:
The cutter is disabled when the take-up reel is in use.
NOTE:
If you want to move the printer, first remove the take-up reel sensor and cable housing unit
from the foot of the printer stand. Place the sensor and cable housing unit on the printer stand crossbar
and use the blue plastic screw to affix the housing unit to the leg of the stand, as shown, while the printer
is being moved. When reinstalling the housing unit, make sure that the wheel on the foot of the printer
stand is pointing forward.
ENWW
Use the take-up reel
33
Hand
le the su
bstrate