HP Designjet L25500 Printer series - Manual (Page 38)

Unload a roll from the take-up reel
1. On the printer's front panel, select the icon, and then select Substrate unload > Unload roll.
The printer advances the substrate to allow for cutting.
2. Lift the loading table to its upright position.
3. Switch the wind-direction switch to the Off position. The switch is in the off position when it is
centered (in other words, when the switch is neither in position 1 nor position 2).
4. Remove the loop-shaping core.
34 Chapter 4 Handle the substrate ENWW
Handle the su
bstrate