HP Secure Key Manager - Manual (Page 219)

Figure 132 Viewing LDAP Administrator Server Properties section
Table 112 LDAP Administrator Server Properties section components
Component Description
Hostname or IP Address The hostname or IP address of the primary LDAP server.
Port
The port on which the LDAP server is listening. LDAP servers typically use port 389.
Use SSL
By default the SKM appliance connects directly to the LDAP server over TCP.
Check this box to use SSL between the device and the LDAP server.
Trusted Certificate
Authority
Select a Trusted Certificate Authority to use to verify that server certificates
presented by LDAP servers are signed by a CA trusted by the SKM appliance.
This option is valid only if you use SSL to communicate with the LDAP server.
Timeout (sec)
The number of seconds to wait for the LDAP server during connections and
searches before timing out. If the connection times out, the authorization fails.
Bind DN
The distinguished name (DN) to be used to bind to the server. The device will
bind using these credentials to perform searches for users and groups. If your
LDAP server supports anonymous searches, you may leave this field and the Bind
Password field empty.
Bind Password The password to be used to bind to the LDAP server.
Edit Click to modify the properties.
Clear Click to remove the current properties
LDAP Test Click to test the LDAP connection after you have defined an LDAP server.
LDAP Schema Properties
The LDAP Schema Properties section describes the schema for your LDAP administrator directory.
Secure Key Manager 219