Power cords, Updating firmware – HP 60-Modular-Smart-Array User Manual
Page 22
Setup 22
For a complete list of supported cables, see the QuickSpecs on the HP website (
Power cords
The power cord should be approved for use in your country. The power cord must be rated for the
product and for the voltage and current marked on the electrical ratings label of the product. The voltage
and current rating for the cord should be greater than the voltage and current rating marked on the
product. In addition, the diameter of the wire must be a minimum of 1.00 mm
2
or 18 AWG, your
maximum length may be up to 3.66 m (12 ft).
WARNING: To reduce the risk of electric shock or damage to the equipment:
•
Do not disable the power cord grounding plug. The grounding plug is an important
safety feature.
•
Plug the power cord into a grounded (earthed) electrical outlet that is easily
accessible at all times.
•
Unplug the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed
against it. Pay particular attention to the plug, electrical outlet, and the point where
the cord extends from the storage system.
To connect AC power cords:
1.
Connect the power cords to the power supplies.
2.
Connect the power cords to the AC power source.
Updating firmware
To update storage enclosure firmware, see "Smart Components for ROM Flash (on page
website (
After installing hardware and powering up the storage enclosure for the first time, be sure to verify that
the host controllers and drives have the latest firmware. For firmware and software updates, refer to the
HP website (
To receive proactive email support alerts such as customer advisories, updates on drivers, software,
firmware, and customer replaceable components, sign up for HP Subscriber's Choice. Go to HP
Subscriber's Choice on th
t the
appropriate product.