HP StoreEver ESL G3 Tape Libraries User Manual
Page 177
IMPORTANT:
Due to anti-malware and library hardware constraints, if you are running library
firmware version 663H or later, you cannot roll back to earlier firmware versions.
If your library is running firmware versions prior to 663H, you cannot use this GUI process to
upgrade to later library firmware versions. To upgrade from an earlier firmware version to version
663H or later, a Controller Board Upgrade Kit must be purchased separately.
NOTE:
Before performing a software upgrade, we recommend that you shut down and restart
the library.
To access the Update Firmware Wizard:
1.
Log on as admin or service.
2.
You can access the Update Firmware Wizard while viewing either the physical library or a
partition. From the View menu, select the name of the physical library or the appropriate
partition.
3.
Select Tools
→Update Firmware→Library.
The Update Firmware Wizard window appears. This window explains the operations you can
perform by using the Update Firmware Wizard.
4.
If you are ready to proceed, click Next. If you are not ready to proceed, click Cancel.
The Library System Software Update window appears. The remaining procedures in this
section start with this window.
Updating library software 177