HP StoreEver ESL G3 Tape Libraries - Manual (Page 74)

•
Enter values in the horizontal and vertical boxes to specify the movement of the screen
saver image in pixels.
•
Enter a value in the Motion Delay box to specify the movement speed of the screen saver
image.
5. Under Images, specify the image files to display for normal functions, warning notices, and
failure notices. You must select image files for all three functions.
•
To specify an image file, click Browse. Select the image file and then click Open. The
image file must be in GIF, JPEG, or PNG format, and cannot be larger than 1 MB. In
addition, image resolution is limited to 600 x 800 pixels.
•
Click Preview to preview an image file.
6. Click OK to save the settings and close the Preferences dialog box.
Or, click Apply to save the settings without closing the Preferences dialog box.
7. Because you made system configuration changes, you must click Yes to save the configuration
changes For more information, see
“Saving and restoring library configuration” (page 120) .
About the configuration record
The configuration record contains details about the library configuration and can be sent to a
specified e-mail address or saved as a .txt file.
Information in the configuration record includes:
•
Product information: Product name and version, MCB and RCU versions, serial number, and
modules/drives/partitions configuration
•
License information: License descriptions, quantities, and installation dates
•
Partition information: Serial numbers, online/offline statuses, and numbers of slots, drives,
and I/E slots
•
Network information: Hostname, DHCP status, IP address, and IP, Netmask, and Gateway
addresses
•
Drive information, for each drive: Location, partition, online/offline status, vendor, model,
serial number, logical serial number, firmware version, drive type, and interface type:
•
Fibre Channel (FC) tape drives - World Wide Name (WWN) and loop ID, speed, and
connection type
Before you can e-mail the configuration record, the library e-mail account must be configured. For
information on configuring the library e-mail account, see
“Configuring e-mail” (page 51) .
Setting aisle lights
Aisle lights are mounted to the roof of each module to illuminate the inside of the library.
To set the duration for aisle lighting:
1. From the main console, select Setup
→Library Settings→Aisle Light.
The Aisle Light Settings dialog box appears.
2. Select a duration for the light to illuminate: 30 minutes, 1 hour, or Always Off.
3. Click OK.
74 Modifying the library configuration