Ag Leader Base Station Hardware Manual - Manual (Page 24)

22 AutoSteer System
Providing Power
7. Rotate the Radio Modem Antenna into an upright position so it fits through the slot on the ground plane of the GPS
Antenna. Verify that the connector is tight.
Note: The antenna should already be connected into the DLINK port.
Note: Once the two Quick-Release Couplers are attached to their respective components, keep them intact and press
the Female Quick-Release Coupler button to move the Base Station on and off the Tripod.
Providing Power
1. Fasten the 12-Volt Battery Power Supply Cable to the bottom of the Base Station. Do not force the cable connector into the
power cable plug-in. Align the widest, single notch of the connector with the matching slot on the plug-in port.
Radio Modem Antenna