Ag Leader Base Station Hardware Manual - Manual (Page 71)

Hardware Installation Manual 69
Mounting in a Permanent Location
3. Verify that the antenna is perpendicular to the ground after it is set up.
Mounting in a Permanent Location
1. Mount mounting bracket to permanent site.
2. Attach the repeater assembly to permanent mounting bracket using U-bolts.
3. Verify that the antenna is perpendicular to the surface of the Earth after it is set up.
Providing Power
1. Connect a fully charged12-volt, deep-cycle marine battery to the power cable using the alligator clips after all of the other
connections have been completed. Since the repeater does not have a power switch, the connect/disconnect battery cable
serves as the switch.