AMX VTM-D15/A - Manual (Page 15)

Installation and Wiring
11 VTM-D15/A 15" MultiMedia Touch Panel Systems
Installation and Wiring
This section covers the steps necessary to setup the individual MultiMedia components and connect
them together. The three areas of focus ar the main component setup, wiring, installation, and
connection.
Setting up the AXB-TPI/3
The AXB-TPI/3 does not come pre-installed with any input modules. The card provided with the
original system package is the TP3-VID Composite/S-Video Input Module. The TPI/3 can be
configured with any combination of 3 input cards (TP3-RGB, TP3-VGA, and/or TP3-VID).
Installing the input modules
1. Discharge the static electricity from your body by touching a grounded metal object.
2. Disconnect any connectors from the AXB-TPI/3.
3. Remove (counter-clockwise) the two-black thumbscrews on the slot cover corresponding to the
location being used for the inserted input module. Any module can be inserted into any slot
number.
4. Gently insert the module into the brackets inside the card slot and slide the input module into
the enclosure until you feel it contact the slot connector, as shown in FIG. 5.
5. Screw in (clockwise) the two thumbscrews to secure the module.
6. Repeat steps 3 through 5 to insert other input modules, if necessary.
Removing input modules
1. Disconnect any power supply connected to the TPI/3.
Always power down the TPI/3 before attempting to remove or install input modules.
Failure to do so could result in damage to the TPI/3 and/or input modules.
FIG. 5 Inserting an input module
Always power down the TPI/3 before attempting to remove or install input modules.
Failure to do so could result in damage to the TPI/3 and/or input modules.