EOTech LWTS Light Weapon Thermal Sight - Manual (Page 60)

2-42
2.26 ALIGNMENT / ZEROING PROCEDURES
(Continued)
7. Align the LWTS reticle with the center of the target per
section 2.20, ADJUST.
8. Fire a 3-round shot group and note the center of the shot
group relative to the designated strike point.
9. Adjust the position of the reticle to move the center of the
shot group to the designated strike point.
10. Fire another 3-round shot group and again observe the
center of the new shot group relative to the designated
strike point.
11. When 2 out of 3 rounds are in the designated strike
zone, the LWTS is aligned to be parallel with the rail of
the host weapon.
Clip-On
When being used in-line with an optical sight, the LWTS
should be placed in CLIP ON mode (see section 2.24) and
zeroing procedures associated with the primary sight should
be used. Placing the LWTS in front of an already zeroed
optic / weapon combination does not necessitate rezeroing.