HUACAM HCV207 - Manual (Page 33)

www.huacam.com 33
5.11 Instructions for local firmware upgrade using TFTP server
1. Unzip the file and put all of them under the root directory of the TFTP server.
2. Put the PC running the TFTP server and the device in the same LAN segment.
3. Please go to File -> Configure -> Security to change the TFTP server's default setting from
"Receive Only" to "Transmit Only" for the firmware upgrade.
4. Start the TFTP server, in the phone’s web configuration page
5. Configure the Firmware Server Path with the IP address of the PC
6. Update the change and reboot the unit
End users can also choose to download the free HTTP server from http://httpd.apache.org/ or
use Microsoft IIS web server.
5.12 Configuration File Download
Huacam SIP Device can be configured via Web Interface as well as via Configuration File
through TFTP or HTTP/HTTPS. “Config Server Path” is the TFTP or HTTP/HTTPS server path
for configuration file. It needs to be set to a valid URL, either in FQDN or IP address format. The
“Config Server Path” can be same or different from the “Firmware Server Path”.
A configuration parameter is associated with each particular field in the web configuration page.
A parameter consists of a Capital letter P and 1 to 3 (Could be extended to 4 in the future) digit
numeric numbers. i.e., P2 is associated with “Admin Password” in the ADVANCED SETTINGS
page. For a detailed parameter list, please refer to the corresponding firmware release
configuration template.
When Huacam Device boots up or reboots, it will issue request for configuration file named
“cfgxxxxxxxxxxxx.xml”, where “xxxxxxxxxxxx” is the MAC address of the device, i.e.,
“cfg000b820102ab.xml”. The configuration file name should be in lower cases.
Currently HCV207 only support XML configuration.