ACS EXP-06E - Manual (Page 10)

EXP-06E Access Control System Installation Instruction
Satcom Systems (International) Co., Ltd.
10
7.3 Equipment Wiring /requirement of EXP-06E
7.3.1 Readers (In/Out) & Keypad
1. Do NOT wiring with any other high power cable. E.g. 220V AC
2. Do NOT install near switches that produce large amount of spark. E.g.
Light.
3. Choose linear power supply for the readers instead of switching power
supply.
4. Follow the cable wiring specification by the manufacturer of readers.
7.3.2 Door Lock Relay Output (IMPORTANT)
1. Install diode parallel to the door lock.
2. ATTENEION: It may affect the performance of EXP-06E when diode
is not installed parallel to the lock. See Figure 1.2.
7.3.3
Door Release Button & Door Sensor
1.
Connect one end of the Door Sensor and one end of the Door Release
Button together to connector pin K.
2. Use AWG 24 wire to connect the Door Release Button with EXP-06E.
3. Do NOT connect Door Release Button and EXP-06E over 50ft.
7.3.4
RS-232 & RS-485
Must use shield twisted pair wire to connect EXP-06E with host computer.
7.3.5
Switching Power Supply
Connect the polarity (positive & negative) correctly. See figure
7.3.6
Event Printer Port
Use DOT-MATRIX Printer to print the update event report.
Electric
Door
Lock