ACS EXP-06E - Manual (Page 8)

EXP-06E Access Control System Installation Instruction
Satcom Systems (International) Co., Ltd.
8
Otherwise, the proximity card reader will sound three sort "beep-beep-beep" for
rejected active by "INVALID AUTHORIZE LEVEL" OR "WRONG PIN CODE".
Remark : Duress Pin Code is the current user pin code add one.
i.e. If the user pin code is 0001 then the duress pin code should be 0002.
6.8 Present Card with Duress Pin Code
If duress alarm function interfaced with alarm control panel, user can use this function
for under duress access. At this function mode, user should place the card on the
present card area, the proximity card reader's LED light will hold on 5 seconds to
green color, user should key in "Duress Pin Code" through the keypad. If the duress
pin code is correct, the proximity card reader will sound a long "beep". Then the door
lock will be released and at the same time access controller send out a duress alarm
signal to alarm control panel. Otherwise, the proximity card reader will sound three
sort "beep-beep-beep" for rejected access by "WRONG CODE".
Remark : Duress Pin Code is the current user pin code add one.
i.e. If the user pin code is 0001 then the duress pin code should be 0002.
i.e. If the user pin code is 9999 then the duress pin code should be 0000.
6.9 Double Pin Code Entry for Duress Pin Code
If duress alarm function interfaced with alarm control panel, user can use this function
for under duress access. At this function mode, user should key in the card number
and duress pin code through keypad instead of card operation. Press "#" key will
enable this function if this operation is set. If user are allowed to entry the area by
using Key Operation, the proximity card reader's LED light will hold on 5 seconds to
green color, user should key in 8 digits card number assigned to the user. If the card
number is "ACCEPTED", the proximity card reader's LED light should still hold
more 5 seconds to key in 4 digits "Duress Pin Code". If the pin code is correct, the
proximity card reader will sound a long "beep". Then the door lock will be released
and at the same time access controller send out a duress alarm signal to alarm control
panel. Otherwise, the proximity card reader will sound three sort " beep-beep-beep"
for rejected access by " WRONG CODE".
Remark : Duress Pin Code is the current user pin code add one.
i.e. If the user pin code is 0001 then the duress pin code should be 0002.
i.e. If the user pin code is 9999 then the duress pin code should be 0000.